Setting limit positions
Limit positions need to be set manually using supplied regulator.
Decrease of the range
Increase of the range
Motors spin direction
Direction of limit position
switches regulation
For setting bottom or top limit position roller shutter needs to be
started (opening or closing direction) until it stops at the factory
set height. For increasing the range of limit position turn the
rotary regulator in the ‘+’ direction. Analogically, for decreasing
the range, turn in the ‘-‘ direction.
Changing motors direction
Programming first transmitter
INSTRUCTION FOR 'R' TYPE MOTORS: 35R AND 45R
Non-compliance with the specification might cause risk for life or health and can determine proper work of the roller shutter.
We strongly recommend to comply with the specification.
Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence
(SEP - Association of Polish Electrical Engineers) or equal license.
www.sukcesgroup.pl
Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
Turn on power supply or press
microswitch (approx. 2 sec.)
when power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will make
a sound.
Press
programming button (P2)
on the remote.
or
Roller shutter will
make an up/down
move as the motor will
make few sounds.
Motor will make
a sound.
Press
programming button
(P2) on the remote.
Press UP button
on the remote.
When pressing DOWN
button roller shutter
moves up.
When pressing DOWN
button roller shutter
moves down.
Roller shutter will make an up/down
move as the motor will make
few sounds.
Press microswitch
for aprox. 6 seconds.