7.
Cleaning and maintenance
• Turn off the device and disconnect it from the external power supply before each cleaning.
• The device must not be cleaned under running water.
• Do not use aggressive cleaning agents.
• Clean the outside and inside of the device with a damp cloth, excluding the control panel and power section.
• Manual defrosting
During long-term operation of the device, a layer of frost may appear inside it. This can reduce its performance.
To defrost the device, disconnect it from the power supply, empty the cooling compartment and leave the door open. After frost has condensed, wipe off
the remaining water with a soft cloth.
• Replacing the fuse
CAUTION! Before replacing the fuse, turn the device off and disconnect it from the power supply.
1. Remove the fuse cover
2. Remove the fuse and replace it with a new one with the same technical parameters.
3. Reinstall the fuse cover.
8.
Troubleshooting the most common faults
• Foodstuffs has been frozen:
Change the cooling temperature to high er one, the set temperature is too low.
• Droplets of liquid appear around the fridge door:
Drops of liquid appear due to the temperature difference between the device and its surroundings and are normal.
• The device makes a sound of flowing liquid:
This sound is normal.
• When starting the device, the compressor makes a loud noise:
It is normal for the compressor to work loudly at start-up
• The device does not work:
- Check that the device is correctly connected to the power source.
- Check if the device has been switched on with the On/Off button .
- Check whether the power supply is operational.
- Check that the fuse has not blown.
• Display error codes:
- Error E1 - Supply voltage too low - Check the car battery charge level and the correct connection of the device to the power supply in accordance with the technical data of
the device.
- Error E2 - Fan overload - Disconnect the device from the power supply and wait at least 30 minutes before restarting it.
- Error E3 - Compressor start error - Disconnect the unit from the power supply and wait at least 30 minutes before restarting it.
- Error E4 - Compressor overload - Disconnect the device from the power supply and wait at least 30 minutes before restarting it. Make sure that the device is not located in a
sunny place and the ambient temperature does not 32°C.
- Error E5 - Compressor controller overheating - Disconnect the device from the power supply and wait at least 30 minutes before restarting it. Make sure that the device is
not located in a sunny place and the ambient temperature does not 32°C.
- Error E6 - Damage to the temperature sensor - Report the fault to the manufacturer's service.
10 A
109mV
7.7 mΩ
115
A²s
Fuse specification
Current Rating
Voltage Drop
Cold Resistance
I2t