Changing the lid opening direction
1. Open and set the lid at a 90° angle
2. Slide the left side of the lid upwards and then remove the pin from the right hole in the housing. If resistance is encountered,
adjust the angle of the lid again.
3. Turn and move the lid over the opposite edge of the housing.
4. Insert the pin into the right housing opening and then insert the left pin into the appropriately profiled cutout.
Current temperature inside the chamber
Button
for changing the target temperature inside the
ventricle
Settings change button
Return to the previous screen
Battery protection
mode change
buttons
(H / M / L)
Cooling mode
change
buttons
(MAX / ECO)
Device on/off button
Restoring the default settings of the application
Disconnecting the Bluetooth connection
Setting the
max
temperature
Setting the m
in
temperature
Setting the compressor start delay after starting the device ( in minutes)
Chamber hysteresis setting - the compressor will start after exceeding the sum
of the set device temperature and hysteresis temperature
(example - cooling temperature set on the device: -20°C, hysteresis temperature:
+ 2°C, compressor restart temperature: -18°C)
Settings enabling leveling of differences between the actual temperature
of the interior of the device and the temperature set on the control panel
(example - chamber cooling temperature set on the device: 0°C,
actual temperature inside the chamber: -5°C, the temperature should be
set to level the + 5°C differences)
Setting delaying / accelerating the compressor off after reaching the temperature
set on the control panel
L
M
H
The description as well as the design may change with future updates to the app.