Yokomo Brushless Speed Controller R160 / R100 Manual
BRUSHLESS SPEED CONTROLLER
R160
R100
● 32 bit processor ● Low resistance FET ● Auto Fan control
System
Brushless
Forward / Brake / Reverse
Factory default setting : Forward / Brake
Size
38.1 × 30.5 × 19 ｍｍ
30 × 30.5 × 12.5 ｍｍ
Weight
42g
20.8g
Voltage Input
4.5V ˜ 11V
6 cell Ni-Cd / Ni-MH Battery
2 cell Li-PO
4.8V ˜ 11V
6 cell Ni-Cd / Ni-MH Battery
2 cell Li-PO
Peak Current
760A
380A
Motor Limit
4.5 Ｔ
10.5 Ｔ
Motor Type
Sensored Brushless Motors
B.E.C
5A / 6V / 7.2V
Thank you for purchasing Yokomo product. This product has been developed to maximize the power of brushless
motor. R160 and R100 competition brushless controllers achieve high operability in wide range of R / C racing
scenes by changing settings. Various programming changes enables to set up according to the operation
(programming card available separately will be required). Please read this manual for settings and operations.
● Use double-sided tape to fix the ESC in safe area.
● Pay close attention to the polarity (+ and -) when
connecting the battery cable. If you make a mistake
b and-when connecting to the battery, the ESC
will be damaged. In addition, please note that the failure
caused by this operation is not covered by the warranty.
Use BEC wire to connect the receiver to the ESC's 3-pin
port. (Do not m and-)
● Solder 3 motor wires to ESC before connecting to the
motor. At that time, connect A-B-C wires of ESC and
A-B-C of motor that matches. When using solder, do not
apply solder for more than 5 seconds as it will become
hot and may damage the ESC. Damage during solder
installation is not covered by the warranty, so be careful
when working. After installing the solder, be careful that
the wires are not in contact with each other. If the wires
are in contact with each other and short-circuited, the
product will be damaged and the warranty will be invalid
● Connect the sensor cable to the ESC and motor.
● Connect the receiver cable to CH2 of the receiver..
* The output voltage of the FAN port is designed to be the
same as the battery voltage.
* A-B-C connected to the motor can be changed to C-B-A
by changing the programming card settings.
■ Specification
■ How to connect