YOKOGAWA FA-M3V e-RT3 Plus, Руководство по оборудованию

Страница: 97 / 274

A2-63
IM 34M06C11-01E
(21) F3YC16-0N Relay Output Module
Item Specifications Item Specifications
Output type Relay contact
Service life
Mechanical 20 million operations or more
Number of points 16 Electrical
100,000 operations or more
(rated load)
Common line type 8 points/common Surge protector *1 None
Isolation method Mechanical insulation
Fuse None
Withstanding voltage
1500V AC for one minute
between the group of
terminals for external
connection and the internal
circuit
Dissipating current 380mA (5V DC)
Rated load
voltage range
(maximum load
voltage)
DC 5-24V (125V) Output display *2 LED (Lit when output is on)
AC 100-240V (264V)
Output status when the
program stops
HOLD/RESET
*3
When a sequence CPU
module is used:
Default: RESET
Can be set globally on a
module-by-module basis.
Maximum load current
2A/point, 8A/common line
(resistive load)
Maximum switching
capacity
530VA/point, or 60W/point
(for resistive load)
Minimum load
voltage/current
5V DC, 10mA
When a BASIC CPU module
is used:
No setting function
The status is always HOLD
Response
time
OFF → ON 10ms max.
ON
→
OFF 10ms max. External power supply Not required
ON voltage ─ External connection
18-point terminal block with
M3.5 screws
Off-time leak current
─
Weight 220g
*1: If an inductive load, such as a relay, is to be connected, a surge protector is required on the load side. Connect a
surge protector or a diode across the load nearby so that the module output terminal voltage will not exceed the
specified operating load voltage range. For details, see Subsection A3.6.5, “Connecting Output Devices.”
*2: The contact operation of the output block of the circuit and the LED display operate independently and thus may be
inconsistent in the event of an error.
*3: For information on the module’s behavior during a CPU failure, see subsection A4.3.3, “Indicating Problem Severity
and Status of Output Module.”
WARNING
Don’t connect DC load and AC load to single module together.
Don’t connect loads from different AC sources to single module together.
In case of using these loads at once, connect to different relay output modules
separately.
Note
The relays in the relay output modules are not of hermetically sealed type.
Dust or corrosive gases in the installation environment adversely affect the service life
of the relays.
Relays that are switched on and off in an atmosphere containing silicone gases from
silicone-based materials may suffer from poor electrical contact due to SiO
2
(silicon
dioxide) formed and deposited on the surfaces of their contacts.
Risks of bad contact due to silicon gases are especially high under load conditions
below 24V DC and 500mA. In such environments, we recommend the use of transistor
output modules or other modules employing semiconductor elements instead.