<8. Setting Parameters>
8-4
IM 01C27B01-01EN
• Block Info
• Block Mode
• Dynamic Variables
• Configuration
• Calibration
• Others
(AI1 DP)
• Tag Description
(Block Info)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode )
• Process Value
• Simulation
(Dynamic Variables)
• Simulate Switch
• Transducer Value
• Simulate Value
(Simulation)
• Process Value.Status
• Process Value.Value **
(Process Value)
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
(Configuration)
(Block Mode)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Scale)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
• Upper Limit
• Lower Limit
• PV Range *
• Linerization Type *
• Flow Constant *
• Lower Cutoff
• Low Cut Mode *
• H/L Swap *
• T Zero Cmp *
• Temp Zero *
• Temp Select *
(Others)
(PV Range)
• PV Range.EU at 100% *
• PV Range.EU at 0% *
• PV Range.Units Index *
• PV Range.Decimal *
F0802-2.ai
• Block Mode
• Cal Cmd *
• Cal Status
• Calibration Highest Point *
• Calibration Lowest Point *
• Calibration Minimum Span
• External Zero Trim *
(Calibration)
(Block Mode)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
• Transducer Value.
Status
• Transducer Value.
Value
(Transducer Value)
• Simulate Value.
Status
• Simulate Value.
Value
(Simulate Value)
Online Menu (continued)
*:
When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).
**: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to Manual.
