4-4
IM DLM4038-03EN
4.3 Video Signal Output (VIDEO OUT (XGA))
CAUTION
• Only connect the DLM4000 to a monitor after turning both the DLM4000 and the monitor
off.
• Do not short the VIDEO OUT terminal or apply external voltage to it. Doing so may damage
the DLM4000.
French
ATTENTION
• Ne brancher le DLM4000 sur un moniteur qu’après avoir mis hors tension le DLM4000 et le
moniteur.
• Ne pas court-circuiter la borne VIDEO OUT et ne pas appliquer de tension de sortie. Cela
pourrait endommager le DLM4000.
Video Signal Output Terminal
6
11
1
5
15
10
D-Sub 15-pin receptacle
You can use video signal output to display the DLM4000 screen on a monitor. Any multisync monitor
that supports XGA can be connected.
Pin No.
Signal Name
Specifications
1
Red
0.7 Vp-p
2
Green
0.7 Vp-p
3
Blue
0.7 Vp-p
4
−
5
GND
6
GND
7
GND
8
GND
9
−
10
GND
11
−
12
−
13
Horizontal sync signal
Approximately 48.4 kHz, TTL negative logic (
)
14
Vertical sync signal
Approximately 60 Hz, TTL negative logic (
)
15
−
Connecting to a Monitor
1.
Turn off the DLM4000 and the monitor.
2.
Connect the DLM4000 and the monitor using an RGB cable.
3.
Turn on the DLM4000 and the monitor.
Note
• An RGB video signal is always running through the VIDEO OUT terminal.
• The monitor display may flicker if you place the DLM4000 or some other device close to it.
• Depending on the type of monitor, parts of the DLM4000 display may be cut off.
