F²MC-16LX Family, Flash Programmer Yokogawa AF220/221
www.cypress.com
Document No. 002-05108 Rev. *B
10
2 . 1 . 2
C o n n e c t i o n t o t h e T a r g e t B o a r d
All devices of the Cypress 16LX-series use at least eight signal lines for serial programming:
SINx, SOTx and SCKx
for serial communication
*1
MD0, MD2, P00, P01
for Mode-setting
*2
RST
for Reset
*
1
:
The used serial interface depends on the microcontroller series.
*
2
:
Instead of P00, P01 other port-pins may be used
Please refer to the AN-MCU-390031-E-vxx Programming Flash MCUs.
Depending on the used interface cable the corresponding pin connection according to Table 1 has to be used.
Figure 17 shows a typical connection between the Yokogawa Flash-Programmer and the target system with a
Cypress 16LX-microcontroller.
Please refer to the Flash-Programmer manual or the hardware manual of the related microcontroller (chapter
“Examples of serial programming connection”) in order to get more detailed information.
Figure 17. Example of connecting with Cypress target system
Vcc
27 (1 brown)
13 (2 red)
6 (12 white&red)
23 (9 white)
12 (4 yellow)
20 (11 white&brown)
19 (13 white&orange)
5 (14 white&yellow)
P01
Yokogawa
Flash-Programmer
AF220/221
Cypress
Microcontroller
16LX
(MB90Fxxx)
SOTx
SINx
SCKx
P00
MD0
MD1
MD2
/RST
TRXD
TTXD
TCK
TAUX
TMODE
TAUX4
TAUX3
/TRES
+
+
+
+
+
1,14,15,28 (black, directly soldered on PCB)
GNDx
GND
2 (20 lightblue)
TVCC
+
VCC
+
3 (18 white&grey)
max 100mA
Note: 1) All pin (number/colours) in brackets are for probe
AZ211 2) All resistors are 10kOhm
