YMGI WMMS-30CH-V2B(59)5, Руководство по обслуживанию, Страница: 31 / 81

YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
31
Functions and Controls
1. Basic functions of the system
Cooling Mode
1.1 Cooling conditions and process :
If the compressor is in stop status and start the unit for cooling operation, when one of the indoor units reaches the cooling
operation condition, the unit start cooling operation; in this case, the electronic expansion valve, the outdoor fan and the
compressor start operation.
1.2 Stop in cooling operation
1.2.1 Compressor stops
The compressor stops immediately, the outdoor fan stops after 1min.
1.2.2 Some of the indoor units reach the stop condition (the compressor does not stop). The compressor operates
immediately according to the required frequency. For the indoor unit with no requirement, the corresponding electronic
expansion valve is closed to OP.
1.3 Cooling mode transfers to heating mode
When the unit transfers to heating mode, the 4-way valve is energized after the compressor stops for 2min. The other
disposals are the same as stopping in cooling mode.
1.4 4-way valve: in this mode, the 4-way valve is closed.
1.5 Outdoor fan control in cooling mode
The outdoor fan starts before 5s of the starting of compressor. The outdoor fan will run in high speed for 3min after starting
and then it will run in set speed. The fan shall run at every speed for at least 80s. (When the quantity of running indoor unit
is changed, the unit will enter the control described in 1.3.5.1 and 1.3.5.2)
When the compressor stops, the outdoor fan runs at present speed and stops after 1min.
Dehumidify Mode
2.1 The dry conditions and process are the same as those in cooling mode
2.2 The status of 4-way valve: closed
2.3 The temperature setting range: 60.8 ~ 86 °F (16 ~ 30 °C)
2.4 Protection function: the same as those in cooling mode
2.5 In dry mode, the maximum value A of the capacity requirement percentage of single unit is 90% of that in cooling mode.
The open condition of the electronic expansion valve, outdoor fan and compressor is the same as those in cooling mode.
Heating Mode (Only for heat pump models)
3.1 Heating conditions and process:
When one of the indoor units reaches the heating operation condition, the unit starts heating operation.