COMPLETE TUNING INSTRUCTIONS FOR THE FLASHLIGHT
CONTENTS
1. General principles of operating and settings
1-1. Engineering menu
1-2. Configuration and settings of slots (commands)
1-3. Preconfigured user interfaces
1-4. Changing of preconfigured user interfaces
2. Thermal control settings
2-1. Manual thermal control setting
2-2. Temperature sensor calibration
3. Some particular qualities of Unicorn 1.0
3-1. Battery check and indication
3-2. Basic features of adjustment
3-3. Smooth adjustment features
3-4. Discrete adjustment features
3-5. Features of the Maximum mode with fast access
3-6. Slots features
1. GENERAL PRINCIPLES OF OPERATING AND SETTINGS
Customization of the Unicorn flashlight operation implies following configuration options:
- bringing to the main menu particular additional options (stroboscope, button lock,
beacon, button backlight, battery check, tactical mode, additional custom mode);
connecting the option with particular command («slot»).
- bringing to the main menu particular options of user interface changing (smooth or
discrete adjustment, memory of modes – on/off, button backlight in the off and on
state); connecting the option with particular command («slot»).
Commands are configured through the engineering menu. (pt 1-1, 1-2).
Green LED in the button indicates confirmation of the command execution or turning on
the function; Red LED indicates disabling of the function (for example, memory of modes
or button backlight).
Engineering menu also allows:
- quickly switch between three pre-configured user interfaces (pt 1-3);
- save the current settings configuration as one of the pre-configured user interfaces (pt
1-4);
- set up thermal control of the flashlight (pt 2-1, 2-2).
1-1. Engineering menu
To access the engineering menu screw the cap until tight while holding the button.
To exit the engineering menu de energize the flashlight (unscrew the cap).
CAUTION!
Before de energizing, make sure that the flashlight is turned off FULLY (button backlight has
gone out or has switched to the permanent mode). Otherwise, unsaved data will be lost!
