YTMC-51N2-M3 MoCA 2.5 Adapter
11
Technical Support
Reset and Factory Reset
To reset the device, press the reset button available under YTMC-51N2-M3. To
reset the device into factory default settings, press the reset button available
under YTMC-51N2-M3 for 10 seconds.
The MoCA status LED is not lit after installing 2 adapters:
This indicates that no coax network has been formed. Try the following: Confirm
that the MoCA port on the adapter is connected to the coax outlet on the wall
Try another coax outlet in a different room to see if the adapters connect Check
to see if a cable or terrestrial TV signal is available on both cable wall outlets
Check your cable junction box to make sure the rooms are connected on the
same splitter
My cable modem or set-top box does not work correctly after
installing the adapter:
The adapter may be incompatible with your cable device -
don’t use
the TV port.
Use a coax splitter to go from the coax outlet to the splitter and then run separate
coax cables to the cable modem/STB and another coax to the adapter.
If you are still having problems, try using a
“MoCA
POE (point of Entry)
Filter”
at the
input of the cable modem/STB, this filter blocks the MoCA signal from passing
through to the device. MoCA POE Filters are available online.
I have DirecTV or DISH network:
These Ethernet-to-Coax adapters are designed for use with Cable TV or Terrestrial
(rabbit ears) TV. Connect your satellite operator for adapters that are compatible
with your TV system.
