ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
9
10
IMPORTANT:PAIRING BETWEEN REMOTE AND RECEIVER
1.Within the 30s after turning "ON" the power supply, press the
transmitter’s “STOP" button for 5s. Then press the transmitter’s
“8H” button until the pairing is successfully activated and all
functions will work normally.
IMPORTANT NOTES
The first step of pairing must be performed within 30s after turning
“ON” the power supply.
1(a). When pairing multiple fans, please ensure the isolation switch
or the power supply to the first installed fan is turned off prior
to pairing further fans. Please pair one fan at a time.
1(b). Please ensure the isolation switch is kept "ON”. The isolation
switch can not act as a light switch as it will impair the remote
receiver.
2.When the transmitter’s functions are disabled, please check the
battery orientation and power level. Low battery voltage will affect
your transmitter’s functions and your fan’s operation.Other remote
controls nearby using the same frequency may interfere with your
fan’s receiver.
3.Please remove batteries from the transmitter if not used for a long
period of time.
4.Remote supports 200w maximum lighting.
IMPORTANT REMINDERS
1.Note: The receiver must be correctly installed in the fan’s hanging
bracket.
2.When the transmitter cannot control the receiver, please check the
battery level and check if similar remote controls your fan nearby
and interferes with each other.
3.Battery’s low power will affect the transmitter’s sensitivity and the
signal reception accordingly. You must replace the battery if its
power is low.
4.Please take the battery out of the transmitter to avoid battery leaks
when not used for a long time.
5.Isolation switch must be connected in the line.
6.When a blackout or otherwise circumstances happen, the light will
work normally after the electricity restores.
Please always make sure that the fan is powered off before cleaning
or maintaining.
PROTECTIVE FUNCTIONS OF THE RECEIVER
Lock protection - The DC motor has a built-in safety feature against
blade or motor obstruction during operation. If something obstructs
the fan blades or motor, the motor will keep trying to run and then
stop operation after 30s.
Please remove obstacles and reset.
To reset: Turn the fan off by remote transmitter and then turn the fan
on.
