RPM-
Port
Vbar
Tele-
Port
Vbar
Telemetry
RPM (ext. Gov.)
Ground (- receiver)
receiver throttle
BEC 5,5-8,4V (+ receiver)
Ground (- receiver)
BEC 5,5-8,4V (+ receiver)
Ground (- receiver)
BEC 5,5-8,4V (+ Receiver)
Ground (- Receiver)
Telemetry
RPM (ext. Gov.)
Ground (- Receiver)
. . .
. . .
. . .
Receiver throttle
BEC 5,5-8,4V (+ Receiver)
Ground (- Receiver)
M
as
te
r
´
Sla
ve
T
ele
m
et
ry
. . . . . .
Not used
Connections:
Master
Telemetry
BEC-Slave
(95+135LVT)
135LVT (V2):
95 + 135 LVT:
The BEC-Slave is for duplicating the cable-diameter and
should be plugged into a free receiver-channel.
The 6-pole JST-Connector under the heatshrink is for
special applications and has no use for standard-
applications in planes or helicopters.
Telemetry:
YGE (preprogrammed):
The YGE-protocol is for example for use with
YGE TexY
(Futaba, Spektrum, FrSky, Core), MSH Brain 2 or Spirit
FBL.
Jeti ExBUS:
If necessary, you have to update the receiver to Jeti
ExBUS. Receiver port E1 or E2 is active.
For programming the ESC via Jetibox-menu of your
Transmitter, ESC-firmware >V.103258 is required.
It is necessary to do a mode setup first, and choose "Jeti
ExBus" as telemetry protocol in the PC-software.
The ESC-parameters can be found as "Mx" in the Jetibox-
menu.
Multiplex MSBv2 Addresses:
2: Voltage
3: Current
4: Motor RPM
5: Temperature
6: Used capacity in mAh
7: Actual opening in %
8: Set opening in %
Since Firmware-version V1.03298 the addresses can be
changed or disabled by using the latest PC-Software.
Graupner:
For programming the ESC via telemetry-menu of your
HoTT V4 Transmitter, ESC-firmware >V.103240 is
required.
It is necessary to do a mode setup first, and choose "HoTT
V4" as telemetry protocol in the PC-software.
Mikado:
By using Vbar Control with NEO it is
not
necessary to do
the mode-programming or PC-Setup. The ESC has an
Auto-Detect and sets all parameters by itself after startup.
Also the telemetry will be automatically set to Mikado, so
you can set all parameters in the transmitter. The YGE-App
has to be installed in your VBC first. This does not apply to
the use with older Vbars like Mini-Vbar or Silverline.
Adapter for using Vbar-Governor and VBC-Telemetry
(available separately):
Warranty:
Our warranty conditions are based on the European
Statuary Warranty
.
Any other requirements are excluded.
That applies in particular to requirements for damage or
injuries compensation due to malfunction or failure. For
damages to property or personal injuries and their
consequences, which developed from our supply or
craftsmanship, we do not take any liability, since we have
no control on handling and use.
YGE - Young Generation Electronics
Otto-Hahn-Str. 1A
49134 Wallenhorst
Germany