Call:
+44 (0)1268 570900
Fax:
+44 (0)1268 732509
Email:
Visit:
www.yewdale.co.uk
9
Instructions for Tracker Side Channels:
N.B
.
This blind should be installed by a person competent in DIY. If in doubt
please consult a professional.
1
.
Ensure that the blind is in the headbox and that it is fully retracted before
the side channels are installed.
2
.
Fix the bottom angle (if required) making sure it is directly in line with the
back and end of the headbox.
3
.
Fix the side channels into the end cheeks with lugs using the supplied 3/16”
screws to secure the headboxes to the side channels through the lugs. To fix
the side channel to the headbox endplate lug, drill a 2mm hole through the
outside of the channel.
4
.
Using the indent provided,
fit the side channel by
drilling 5mm fixing holes at
maximum 1000mm centres,
with 9.5mm access holes
in the front as shown in the
diagram.
5
.
Ensure the back of the side channel lines up directly with the back of the
headbox and not fitted past it. Make sure that the side of the side channels
extend no further than the side of the headbox or causes an overhang of the
headbox. The side channel and headbox back and side must be absolutely
flush with each other. If it is fitted out of-line the blind will not lower easily
due to the fabric being stretched too far. Please see images below for
further guidance.
Face Fix
Recess Fix
