7
BELT ASSEMBLY INSTRUCTIONS
At the start point, see view of head and tail assembly. Feed a cable or rope through the head
assembly down to the tail assembly. Now attach the belt to the rope/cable and use the
rope/cable to pull the belt through the tube. Make sure the rough side is up and the smooth
side is down against the inside wall of the tube.
Route both ends around head and tail roller, slide belt forward and back through tube so ends
of the belt meet at a convenient location.
Align and interlace belt and clipper lacings. Slip splice pin through clipper lacings to secure.
NOTE: The clipper lacings are connected on a metal strip that needs to be broken to allow
the belt to flex.
Tighten belt by turning adjustment nuts on head roller assembly in. Tighten evenly on each
side until belt is tight.
To train belt, see belt training instructions in this manual, page 6.
Break metal strip
between clipper
lacings to allow belt
to flex.
Содержание MAXIMIZER
