Yetter 2968-026, Инструкция по установке / Каталог запчастей, Страница: 2 / 40

2
TABLE OF CONTENTS
FOREWORD …………………………………………………...….…............... 3
SAFETY …………………………………………………………...….................. 4
PICTORIAL PART LIST ………………………………….................... 5 – 13
INSTALLATION …………………………………………………....…..... 14 – 19
OPERATION .....………………..…………………......................... 19 – 20
MAINTENANCE …………………………….......………................. 21 – 23
PARTS IDENTIFICATION………………………………...…............ 24 – 37
BOLT TORQUE
Important: Over-tightening hardware can cause just as much damage as under-tightening.
Tightening hardware beyond the recommended range can reduce its shock load capacity.
All hardware is either Grade 5 unless otherwise noted. Grade 5 cap screws are marked
with three radial lines on the head. Grade 8 cap screws are marked with six radial lines on the
head. If hardware must be replaced, be sure to replace it with hardware of equal size, strength
and thread type. Refer to the torque values chart when tightening hardware.
The chart below is a guide for proper torque. Use it unless a specified torque is called out
elsewhere in the manual. Torque is the force applied to the end of the handle or cheater bar,
times the length of the handle or bar. Tightening hardware beyond the recommended range can
reduce its shock load capacity.
Use a torque wrench wherever possible
The following table shows torque in ft.-lbs. for coarse thread hardware.