Unit 1 Westfield Court | Barns Ground | Clevedon | Bristol | BS21 6FQ | UK
Tel No: +44 1275 217060 | Email: [email protected]
SMARTBENCH V1.1
22
Set Z datum (start point for the job)
Once the X/Y datum is defined, the tip of the router cutter needs to be registered relative
to the material. This is referred to as setting the Z datum and should be done near the X/Y
datum. Start by going to the X/Y datum:
•
Go to the Map Screen
•
Press
‘
Go to X/Y Datum
’
to place the Z Head at the X/Y datum
Содержание 20731
Страница 1: ...Quick Start Guide...
