Yenista Optics OSICS, Руководство пользователя

Страница: 183 / 252

Using the OSICS T100 Module
OSICS User Manual 183
BKR
TL
S-50
AT
N
DFB
ECL
T10
0
SL
D
SW
T
TLS
-A
G
SW
T
A
PC
MA
IN
13.6 Activating the Auto-peak Find Function
Subject The Auto peak find function generates current pulses in order to stabilize the cavity
operating conditions and stabilize the linewidth.
When implemented, the
Auto peak find function generates a small power fluctuation
during a brief instant that may disrupt certain applications.
If enabled, the
Auto-peak Find is performed 1 second immediately after the laser output
is enabled and then every 10 minutes afterward.
Procedure 1. Access the T100 Unit Setup menu (see section Accessing an OSICS Module Setup
Menu, p. 33 ).
2. Turn the rotary knob to put the cursor before the Auto peak find menu and press
the knob.
The
Auto peak find menu appears and the cursor points to the current setting.
Figure 134: T100 Unit Setup – Auto peak find menu
3. Turn the rotary knob to put the cursor before the wanted setting, and press it to
validate your selection.
The new state is implemented immediately. The
Unit Setup menu is automatically
displayed.
In the OSICS
System Status screen, the message A is displayed in the OSICS module
channel Info field if the Auto peak find function is currently enabled on this module.
Main
EXIT
1 2 3 4 5 6 7 8
Unit Setup - Auto peak find
ESCAPE
▲
Auto peak find :
OFF
ON
Select a new value.