Yenista Optics OSICS, Руководство пользователя

Страница: 145 / 252

Using the OSICS SWT Module
OSICS User Manual 145
BKR
TL
S-50
AT
N
DFB
ECL
T10
0
SL
D
SW
T
TLS
-A
G
SW
T
A
PC
MA
IN
11.3.3 Launching/Stopping a Sequence
Subject The Control sub-menu enables you to launch the sequence once or continuously.
Before Starting Make sure the sequence number of scans (see section Selecting the Number of Scans,
p. 143 ) and time (see section Setting the Timeframe, p. 144 ) are set.
Procedure 1. Access the SWT Unit Setup menu (see section Accessing an OSICS Module Setup
Menu, p. 33 ).
2. Expand the Sequence Switching menu and enter the Control sub-menu.
Figure 103: SWT Unit Setup – Sequence Switching - Control
3. Turn the rotary knob to put the cursor before the wanted action:
• STOP : the SWT module executes the sequence once.
• CONTINUOUS : the SWT module executes the sequence continuously. The
sequence will only stop if you select the STOP action.
4. Press the knob to start the sequence switching.
The sequence starts. In the
System Status screen, an s and the currently activated
channel or mode are displayed in the corresponding SWT module Info field.
5. To stop the sequence if you have selected CONTINUOUS: in the Control sub-menu,
turn the rotary knob to put the cursor before STOP and press the knob to confirm
your selection.
Main 1 2 3 4 5 6 7 8
SWT Unit Setup - Control
▲
Switching mode:
STOP
START
CONTINUOUS
Select a new value.
EXIT ESCAPE