yeep.me TWENTY, Инструкция по эксплуатации

Страница: 20 / 26

EN
20
elements and screws tightened and in good condition.
• Check the tightness of the screws, the front and rear wheels, shock
absorbers, and bonnet, and tighten again if necessary. These adjustments
may be needed because of vibrations caused by using the device.
• The condition of the tyres. Tyre pressure if the unit is equipped with air
wheels, and inflate as soon as is necessary using a bicycle pump or similar.
• The brakes, drum linings, brake pads, foot brake, depending on the unit. If
the unit is equipped with mechanical brakes (disc, drum, foot), ensure they
are not rubbing due to cable tension or exhibiting any other problems, as this
may cause the unit to slow down and prevent it from operating normally.
Overheating may impact the
brake’s efficiency.
• Check that the electric brake is functioning properly if the unit is equipped
with one.
If after adjusting you notice looseness that may affect your ability to drive
safely, or if an unusual noise appears, or a lack of fluidity is apparent, stop
using the unit and contact your dealer for more information or care.
If the product, a component, or the battery are worn out, please contact an
authorised service centre to repair or recycle your product.
MAINTENANCE AND SPARE PARTS :
Your bike requires regular maintenance for your safety but also to increase
its life span. It is important to check the mechanical components periodically
to ensure that worn or worn parts are replaced if necessary.
The battery must be removed before each maintenance operation
.
WARNING: When replacing components it is important to use original parts to
maintain the performance and reliability of the bicycle. Only manufacturer’s
parts are considered original parts.
WARNING: It is the responsibility of the user in case of purchase and use of
fake (counterfeit) parts that subsequently cause damage to the product,
person or environment.
Make sure to use appropriate spare parts for tires, inner tubes, transmission
elements and various components of the braking system. If you have any
questions, please contact the service department or your dealer.
The manufacturer cannot be held responsible for improper use or incorrect
installation.
WARNING 1 : Like all mechanical components, EPAC is subject to wear
and high stress. Different materials and components can react to wear
or stress fatigue in different ways. If a
component’s rated life has been