Yedoo Trexx, Руководство пользователя, Страница: 4 / 23

7 6
EN EN
2.
5.
3. 1.
4.
The installation is the same for both
models (Wolfer, Trexx), it differs only
in minor details (see additional pictures).
When tightening the connections do not
exceed the specified tightening torque.
Installing the front wheel
Insert the quick release into the wheel,
so on the both sides of the wheel the
narrow ends of the springs face the
center of the wheel.
Tighten the adjustment nut of the quick
release so you will feel a noticeable
resistance just before you close it
completely. Close the quick release lever
in a position so it does not touch the fork
and simultaneously it cannot be opened
accidentally while riding. Handlebars installation
Insert the handlebars on the stem
and tighten the screws of the sleeve.
The labels (not shown in a picture)
should be clearly visible from
the front view.
Firstly, check the front fork of the
scooter if it is in the right direction
(V-brakes shoulders should point
forwards), then release the brake
jaws by rotating the lever. Insert the wheel into the front fork
so it is exactly in the middle.
Caution:
The tire tread should face forward in the
riding direction (see arrow on the side of
the casing).
Wolfer
Trexx
6.a 6.c
7.a 7.b 7.d
7.c
6.b
Installing the rear wheel
Release the brake wire from the guide
(
1 ), Put the wheel in one of the two fork
dropouts (see 6.b, 6.c.) then center the
wheel and tighten the quick release (
2 ).
Two-position rear fork enables to
adjust the height of the footrest. Use the
bottom position for riding in a terrain.
Close the quick release lever. It should
point upwards. The upper fork position, which reduces
the height of the footrest, is designed to
ride on a smooth, flat surface. Riding will
be less physically demanding. Close the
quick release lever downwards.
Adjusting the height of the handlebars
Loosen the screws on the stem and
adjust the handlebars to the desired
height using spacer rings. To set the
handlebars to the lowest position,
turn the stem so it points downwards,
see fig. 7.c. After adjusting the handlebar
height, first tighten the headset screw
(
1 ), then the side screws ( 2 , 3 ).
1
1
2
2
3
5–6 Nm 5–6 Nm
5–6 Nm
Installation manual
6–8 Nm