Yeastar K2 IPPBX Hardware Installation Guide | 1 - Hardware Installation Guide | 7
Step 1. Identify the Static Rail Kit Contents
Locate the components for installing the rail kit assembly:
•
Two static rails.
•
Two chassis rails.
•
Two Velcro straps.
Step 2. Install and Remove Tool-less Static Rails (Four-Post)
1.
Position the left and right rail end pieces labeled FRONT
facing inward and orient each end piece to seat in the holes on
the front side of the vertical rack flanges.
2.
Align each end piece in the bottom and top holes of the first
U.
3.
Engage the back end of the rail until it fully seats on the
vertical rack flange. Repeat these steps to position and seat
the front end piece on the vertical flange.
4.
To remove the rails, pull on the latch release button on the
end piece midpoint and unseat each rail.
Step 3. Configure Flush-Mount Static Rails (Two- or Four-Post)
Note:
The rails must be converted to tooled rails
to install in threaded four-post or flush-mount two-post
racks.
1.
Lay both rails with the end pieces facing up. Remove the
two screws on the front end pieces and rotate each piece 180
degrees.
2.
Reattach both end pieces with the two pairs of screws.
