Yealink VP59 Teams, Руководство администратора

Страница: 167 / 533

Administrator’s Guide for VP59/SIP-T58A/CP960 IP Phones
164
Off soft key during the call to disable it.
Default 0
Supported
Devices
All phones except CP960
Web UI Settings > Voice > Acoustic Shield > Acoustic Shield Mode
Parameter features.acoustic_shield.level <y0000000000xx>.cfg
Description
It configures the noise suppression level for handsets and headsets.
The higher value represents the better noise suppression effect.
If it is set to 3, the phone automatically shields the noise out of 20 centimeters (7.9 inches) when you
are using the phone handset or a headset.
Permitted
Values
Integer from 1 to 3
Default 2
Supported
Devices
All phones except CP960
Smart Noise Filtering
The phones can block out the slight noise from the far party when there is no speech in a call, and at the same time
filter out the common transient noise (door closing, table knocking, and so on).
Topic
Smart Noise Filtering Configuration
Smart Noise Filtering Configuration
The following table lists the parameter you can use to configure smart noise filtering.
Parameter features.noise_filtering_rev.enable <y0000000000xx>.cfg
Description
It enables or disables the phone to block out the slight noise from the far end when there is no speech
in a call.
Note: After smart noise filtering is enabled, if the far end is playing music or calling a voice service, the
background music will also be eliminated when there is no speech in a call.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Settings > Voice > Smart Noise Filtering > Smart Noise Filtering
DTMF
DTMF (Dual Tone Multi-frequency) tone, better known as touch tone. DTMF is the signal sent from the IP phone to
the network, which is generated when pressing the IP phone’s keypad during a call. Each key pressed on the IP
phone generates one sinusoidal tone of two frequencies. One is generated from a high-frequency group and the
other from a low-frequency group.
Topics
DTMF Keypad
Transmitting DTMF Digit