Yealink VC110, Руководство администратора

Страница: 77 / 268

Configuring Network
65
Because Internet Protocol version 4 (IPv4) uses a 32-bit address, it cannot meet the
increased demands for unique IP addresses for all devices that connect to the Internet.
Therefore, Internet Protocol version 6 (IPv6) is the next generation network layer
protocol, which designed as a replacement for the current IPv4 protocol.
IPv6 is developed by the Internet Engineering Task Force (IETF) to deal with the
long-anticipated problem of IPv4 address exhaustion. Yealink IP Phone supports IPv4
addressing mode, IPv6 addressing mode, as well as an IPv4&IPv6 dual stack
addressing mode. IPv4 uses a 32-bit address, consisting of four groups of three decimal
digits separated by dots; for example, 192.168.1.100. IPv6 uses a 128-bit address,
consisting of eight groups of four hexadecimal digits separated by colons; for example,
2026:1234:1:1:215:65ff:fe1f:caa.
VoIP network based on IPv6 can provide end-to-end security capabilities, enhanced
Quality of Service (QoS), a set of service requirements to deliver performance
guarantee while transporting traffic over the network.
If you configure the network settings on the phone for an IPv6 network, you can set up
an IP address for the phone either by using SLAAC (ICMPv6), DHCPv6 or by manually
entering an IP address. Ensure that your network environment supports IPv6. Contact
your ISP for more information.
IPv6 Address Assignment Method
Supported IPv6 address assignment methods:

Manual Assignment: An IPv6 address and other configuration parameters (e.g.,
DNS server) for the IP phone can be statically configured by an administrator.

Stateful DHCPv6: The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) has
been standardized by the IETF through RFC 3315. DHCPv6 enables DHCP servers to
pass configuration parameters such as IPv6 network addresses to IPv6 nodes. It
offers the capability of automatic allocation of reusable network addresses and
additional configuration flexibility. This protocol is a stateful counterpart to ―IPv6
Stateless Address Autoconfiguration‖ (
RFC 2462 ), and can be used separately or
concurrently with the latter to obtain configuration parameters.
How the IP phone obtains the IPv6 address and network settings?
The following table lists where the IP phone obtains the IPv6 address and other network
settings:
DHCPv6 How the IP phone obtains the IPv6 address and network settings?
Disabled
You have to manually configure the static IPv6 address and other
network settings.