Accessing the web user interface:
Account Settings:
Click on
Account
->
Register
->
Account X
(X=1,2,3...15,16)
Parameters of the account:
Network Settings:
Account Settings:
Configuring via phone user interface
Configuring via web user interface
Register status icons on the LCD screen:
1. Press the
OK
key when the phone is idle to obtain the IP address of the phone.
You can configure the network settings in the following ways:
It shows the register status of the current account.
You can select Enabled/Disabled to enable/disable the account.
It is shown on the LCD screen to identify the account.
It is shown as caller ID when placing a call.
It is provided by ITSP for registration (required).
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
DHCP:
By default, the phone attempts to contact a DHCP server in your network to obtain its valid network
settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address:
If your phone cannot contact a DHCP server for any reason, you need to configure the IP
address, subnet mask, gateway address, primary DNS address and secondary DNS address
for the phone manually.
Press the
Menu
soft key when the phone is idle, select
Advanced
(default password: admin)->
Network
->
WAN Port
/
VLAN
/
Web Server
/
802.1x
/
VPN
/
LLDP
/
CDP
/
NAT
to configure the network.
Press the
Menu
soft key when the phone is idle, select
Advanced
(default password: admin)->
Accounts
to
configure theaccount.
2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10"
or "192.168.0.10") and then press the
Enter
.
Register Status:
Line Active:
Label:
Display Name:
User Name:
Register Name:
Password:
Server Host:
3. Enter the user name (default: admin) and password (default: admin) in the login page and click
Confirm
.
Network Settings:
Click on
Network
->
Basic
->
IPv4 Config
Registered
(Green)
3
Configuring Your Phone
Note:
The IP phone also supports IPv6, but IPv6 is disabled by default.
The wrong network settings may result in the inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Note:
Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
Note:
For more information on account parameters, refer to
Configuring via web user interface
above.
Register Failed
(Gray)
Registering
(Yellow)
