Yealink SIP-T19 E2 T4 Series, Руководство администратора

Страница: 117 / 981

Setting Up Your System
95
e)
If you select
EAP-PEAP/GTC
:
1)
Enter the user name for authentication in the
Identity
field.
2)
Enter the password for authentication in the
MD5 Password
field.
f)
If you select
EAP-TTLS/EAP-GTC
:
1)
Enter the user name for authentication in the
Identity
field.
2)
Enter the password for authentication in the
MD5 Password
field.
g)
If you select
EAP-FAST
:
1)
Enter the user name for authentication in the
Identity
field.
2)
Enter the password for authentication in the
MD5 Password
field.
3.
Click
Save
to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4.
Press
OK
to reboot the phone.
Setting Up Your Phones with a Provisioning Server
This chapter provides basic instructions for setting up your IP phones with a provisioning server.
This chapter consists of the following sections:

Provisioning Points to Consider

Provisioning Methods

Boot Files, Configuration Files and Resource Files

Setting Up a Provisioning Server

Upgrading Firmware

Keeping User Personalized Settings after Auto Provisioning
Provisioning Points to Consider

If you are provisioning a mass of IP phones, we recommend you to use central provisioning
method as your primary configuration method. For more information on central
provisioning, refer to
Central Provisioning on page 97 .

A provisioning server maximizes the flexibility you have when installing, configuring,
upgrading, and managing the IP phones, and enables you to store boot, configuration, log,
and contact files on the server. You can set up a provisioning server on the local area
network (LAN) or anywhere on the Internet. For more information, refer to
Setting Up a
Provisioning Server on page 108 .

If the IP phone cannot obtain the address of a provisioning server during startup, and has
not been configured with settings from any other source, the IP phone will use
configurations stored in the flash memory. If the phone cannot obtain the address of a
provisioning server and has previously been configured with settings, it will use those