If you are using a Jabra pro
9460/9470
/Motion office
; follow these instructions:
With the headset sitting on the base please press the spanner in the top right corner.
use the arrow to scroll down to phone settings then click that. click on desk phone
click on setup desk phone
It will bring up a message saying you will be unable to make calls. Press confirm. It
will then ask if you would like guided or manual setup - click Manual please.
Select Adapter
–
DHSG
Set clear dial tone switch - Select A by pressing the + button. Then press the right arrow at the
bottom
Set microphone level - 7 is usually fine (can always come back and change this later if
required). Then press the right arrow down the bottom
It will then say setup complete - press the right arrow at the bottom It will
then say the base will restart - click the X in the bottom right.
The base should restart and you should now be able to answer/end from the headset.
If you are using an Engage 65 follow these instructions:
You will need to access the voice-guided menu as per above, use the call button to toggle through the
different options until you hear Hook Lifter type.
Once you hear this use the volume up/down buttons to cycle through the options till you hear DHSG.
Then use the Call button to accept this setting and move on. Then press and hold the volume up and
down button to exit the settings menu and save changes. Place headset back onto the base which will
restart.
