Yealink CPE80, Руководство администратора

Страница: 54 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
38
Mute Indicator LED on the VCM30 video conferencing microphone array
LED Status Description
Solid red The VCM30 is muted when the VC110 is during a call.
Flashing red The VC110 is ringing.
Solid green
The VCM30 is connected to the cable hub within the first 5
seconds.
The VC110 is placing a call.
The VCM30 is unmuted when the VC110 is during a call.
Off
The VCM30 is not connected to the cable hub.
The VCM30 is idle.
User Interfaces
Three are two ways to customize the configurations of your endpoint:

Web User Interface

Remote Control
The following describes how to configure the VC110 video conferencing endpoint via the two
methods above.
Detailed operation steps will be introduced in the feature section.
Web User Interface
You can customize your endpoint via web user interface. To access the web user interface, you
need to know the user name and the administrator’s password. The default user name is “admin”
(case-sensitive), and the default password is “0000”. You can also access the web user interface
with user credential, which is disabled by default. For more information on how to enable the
user credential, refer to
User Mode on page 249 .
The endpoint uses the HTTPS protocol to access the web user interface by default. For more
information on the access protocol for web user interface access, refer to
Web Server Type on
page 251 .
Log into the web user interface of the endpoint:
1.
Enter the IP address (e.g.,192.168.0.10) in the address bar of a web browser on your
computer, and then press the
Enter
key.
2.
Enter the administrator user name and password.
3.
Click
Login
.
After you log into the web user interface successfully, you can click
Logout
on the top
right corner of the web interface to log out.
Administrator has full permission to access every menu in the web user interface. User can log