Chrono-Tester User Manual
v1.2
3
www.the-YCG.com
OPERATING INSTRUCTIONS
Pulse Detection:
1) Power up the Chrono-Tester and place unit in Track Mode.
2) Connect output of chronograph light screens to Start Out & Stop Out inputs on Tester.
3) Connect the Start In & Stop In inputs of Tester to output of chronograph.
4) When a pulse is detected on either the Start or Stop input channels the corresponding
blue LED will illuminate on the Tester.
5) Since the Tester is connected in series as a pass thru device the Tester can remain
connected and not affect the operational accuracy of the ballistic chronograph setup.
6) Press Reset button to clear the LEDs.
Testing Cables:
1) Power up the Chrono-Tester and place unit in Test Mode.
2) Connect cable to be tested to the Tester Start In and Start Out inputs.
3) Press the Pulse Out button; the Tester will output a test pulse on the Start Out and if the
Start In receives the pulse, the Blue Start LED will illuminate.
4) Press Reset to clear the LED.
5) A second cable can be tested simultaneously on the Stop In & Stop Out as well.
