Ybravo BRAVO 25, Руководство оператора

Страница: 7 / 16

7
ASSEMBLY - SETUP
STEP 2
Slide the upper handle assembly into the two lower tubes.
Insert the two carriage bolts and use one square washer (1) on
each side of the handle tube.
STEP 3
To simplify the alignment of the handle, install the grass
catcher.
Tighten the bolts in the following order:
1 - Tighten the two bolts crews on the right side tube clamps
2 - Align the left tube with the catcher (same as the right side)
and tighten the clamps.
3 - Tighten the upper bolts that attaches the handle assembly
to the tubes.
I nstall the right side front
bolt and insert the mulch
plug to hold the bolt
during installation.
I
nstall the nuts fi nger
tight. Tighten completely
in step 3.
1
2
3
STEP 1
Install the black handle tubes to the mower with the M8
carriage bolts. Do not tighten the nuts. There are three holes
for the upper clamp to enable height adjustment. A good start-
ing point is the middle hole for a medium height setting.
UNPACKING:
Carefully remove the mower from its packaging and check that
you have all the following items:
Upper Handle complete
(2) Lower Handle tubes
Mower Bag and Mulch Plug (installed on the mower)
Tool kit
Engine Owner’s Manual and Warranty Statement
Bravo 25 Operator’s Manual.
NOTICE:
If you are missing any of these items or if you are unsure of
how to properly assemble this mower please contact
Ybravo.
com by e-mail or by phone: 888.ybravo1 (888.927.2861)
Tools needed for assembly:
2 pcs 10mm wrenches
1 pcs 13mm wrench
1 pcs Needle nose pliers
Needle Nose
Pliers
10 mm
13 mm
10 mm
1