YBA DESIGN MKII, Руководство пользователя

Страница: 8 / 20

Using your YBA Remote Control
Note: PRESS means a short press on a key while HOLD means to keep the key pressed for more than 3
seconds. Always point the remote towards the IR window of your Signature PRE MKII.
12
Select the device you want to control between AMP, CD and AUX. To
control the Signature PRE MKII, you need to select AMP button.
Press AMP to turn on your pre-amplifier.
Hold (> 3 seconds) AMP button to turn off your pre-amplifier.
Note: AMP will remain the active function until you press another
device.
11
CAUTION Before connecting any input or output.....
Always make sure your Signature PRE MKII is in the OFF position. If you have any doubt, unplug the AC power
cable from the wall.
Make sure any components connected to your Signature PRE MKII are off.
Neatly arrange and organize wiring to and from your Signature PRE MKII and to and from all your components.
Separate AC wires from audio cables to prevent hum or other unwanted noise from being introduced into the
system.
/SOURCE-: Press /SOURCE- to skip to the desired
source.
/VOLUME-: Press to increase the volume or
VOLUME- to decrease the volume. This is a universal control and does
not require specific source selection.
FCT: Hold (>3 seconds) to hold the current volume level.
AUDIO: Press to resume the stored volume level.
1
0
2
2
3
4
6
5
1
2
3
4
5
6
0
VIEW: Hold (>3 seconds) to switch ON/OFF the display (dimmer).
MUTE: Press to mute. Press again to exit mute.
phase from this button. Hold (>3 seconds) for PHASE switching. When
the PHASE LED is on (amber) the pre-amplifier generates a 180
degree
phase shift between the input and output signals. When the LED is off,
this does not occur.
You can also control the
Signature Pre Amplifier MKII
www.ybahifi.com
Page 8