YBA DESIGN Heritage A200, Руководство пользователя

Страница: 7 / 22

I N T E G R A T E D A M P L I F I E R
H e r i t a g e A
200
DIGITAL POWER
ON
OFF
R L XLR
PRE OUT VIDEO CD DVD TUNER AUX
UPGRADE
PORT
R
L
V Hz W
N
330
R L
D e si gn ed in F r a nc e
USB OPTICAL
3 5 6 7 1 2
8 9 10
4
Heritage A200 Integrated Amplifier
Page 7
www.ybahifi.com
Discovering your A200: Rear view
4
CAUTION:
Before connecting or disconnecting any input or output:
Always make sure your A200 is in the OFF position. If you have any doubt, unplug the AC cable from
the power inlet.
Make sure all components connected to your amplifier are all set to off.
Neatly arrange and organize wiring to and from your A200 and to and from all your components.
Separate AC wires from audio cables to prevent hum or other unwanted noise from being introduced
into the system.
2
3
RCA Audio inputs: Connect the RCA outputs of your source to the RCA inputs of your A200. Be sure to
connect the RIGHT output of your source to the R input of your amplifier and the LEFT output to the
L input of your amplifier. Your A200 allows the connection of 5 external, line level sources.
Note that the VIDEO input has a bypass feature. When you select VIDEO and then press < > OK in
sequence, the pre-amplifier is bypassed. By pressing < > OK in sequence once more the A200 returns
to its normal operating mode.
PRE 0UT: Pre-amplified output. If you want to use a subwoofer, a separate power amplifier or some
active speakers, use this connection.
1
Balanced Audio input: This is a higher quality input that can reject noise and interference in the cable
when used with equipment with balanced outputs.
XLR connectors should be wired: Pin 1 - Ground; Pin 2 - Hot (in-phase); Pin 3 - Cold (phase-inverted).
Should you wish, you can disconnect power to the digital section of your A200 when using an analogue
source. Remember to re-engage this switch when using any digital input.
Upgrade port: For service and future improvements. Not for use by end-users.
5