YATO YT-82830, Руководство пользователя

Страница: 15 / 112

15
O R I G I N A L I N S T R U C T I O N S
GB
SPECIFICATION OF THE PRODUCT
Cordless grass trimmer is used for decorative forming of lawns, by using a plastic line, which is rotating at high speed. Because of
the electric drive of grass trimmer its operation is much quieter than in the case of combustion tool, its operation is also possible in
vicinity of buildings. Due to the battery power supply, the grass trimmer allows you to work in areas, which are not accessible for to
mains-powered products. Correct, reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, no compliance
with with safety regulations and recommendations included in this manual, the supplier does not accept any liability. The tool
misuse causes also the loss of user’s rights to the guarantee and warranty.
EQUIPMENT OF THE PRODUCT
The product is supplied in a complete state but before the fi rst use it is required to assembly it. The product is supplied with the
blades covers, front handle rechargeable battery and charging station.
Attention! The product of the catalog number: YT-82831 has not been equipped with a rechargeable battery and charging sta-
tion.
TECHNICAL DATA
Parameter Unit Value
Catalog number YT-82830, YT-82831
Rated voltage [V] 18 DC
Cutting speed [min
-1
] 7200
The length of cutting [mm] 250 / 300
Cutting line diameter [mm] 1.65
Length of cutting line on the spool [m] 2.5
Electric protection class III
Weight [kg] 2.74
Noise level
- L
pA
(pressure) [dB (A)] 85.0 ± 3.0
- L
wA
(power) [dB (A)] 93.0 ± 3.0
Vibrations [m/s
2
] 2.5 ± 1.5
Type of the battery* Li-Ion
Capacity of the battery* [Ah] 2
Energy of the battery [Wh] 36
Charging station*
Input voltage
[V~] 220 - 240
Mains frequency [Hz] 50 / 60
Rated power [W] 60
Output voltage [V] 21 DC
Input current [A] 2.4
Time of charging** [h] 1
* only for models equipped with battery and charger
* * charging time applies only to the battery with a capacity listed in table
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.