YATO YT-828291, Оригинальное руководство пользователя

Страница: 13 / 128

13
O R I G I N A L I N S T R U C T I O N S
EN
PROPERTIES OF THE TOOL
The angular grinder is an electric tool designed for grinding and cutting metals as well as mineral construction materials, such as
bricks, natural and arti fi cial stone, concrete, glaze, etc. with abrasive disks and grinding wheels selected for the given material.
The tool must not be used for processing other materials than those mentioned above, e.g. for grinding and cutting wood or pol-
ishing. A correct, reliable and safe functioning of the grinder depends on its proper use, so:
Before you proceed to operate the grinder, read the manual thoroughly and keep it.
Always use protective goggles!
Do not use grinding wheels whose maximum acceptable tangential velocity is lower than 80 m/s!
Do not use grinding wheels whose maximum acceptable rotational speed is lower than the rotational speed of the grinder.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The product is supplied in a complete state but it requires some installation activities before starting its operation. The product is
supplied with the battery charger and charging station (charger). abrasive disk guard, the wrench for mounting the grinding wheel
and the auxiliary handle. The equipment does not include grinding wheels. The YT-828291 product is supplied with no battery
and no charging station.
TECHNICAL PARAMETERS
Parameter Unit Value
Catalog number YT-82829, YT-828291
Mains voltage [V] 18 DC
Rated revs [min
-1
] 2000 - 9000
Diameter of the abrasive disk [mm] 125
Diameter of the abrasive disk hole [mm] 22,2
Spindle tip M14
Weight [kg] 1,6
Noise level
- accustic pressure LpA ± KpA
[dB (A)] 82,6 ± 3,0
- power L
wA
± K [dB (A)] 93,6 ± 3,0
Vibration level
ah, AG
± K
[m/s
2
] 6,2 ± 1,5 / 5,8 ± 1,5
Insulation class III
Degree of protection IPX0
Type of the battery Li-Ion
Capacity of the battery* [Ah] 3
Charger*
Input voltage
[V] 220 - 240
Mains frequency [Hz] 50 / 60
Output voltage [V] 21 DC
Input current [A] 2,4
Rated power [W] 60
Time of charging** [h] 1,5
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain in fl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with in fl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.