6
O R I G I N A L I N S T R U C T I O N S
GB
PRODUCT CHARACTERISTICS
Solar Spotlight LED is used to illuminate places to which the electric grid cannot be available. Thanks to the solar panel, which
consists of photovoltaic cells connected to the re
fl
ector with a cable, it is possible to have a wide selection of the mounting loca-
tions for the elements of the set. Built-in rechargeable high capacity battery allows for a long period of illumination, The twilight
sensor with adjustable parameters allows for automatic switching on the lamp at dusk, when a motion is detected. Proper, correct,
reliable, and safe operation of the product is dependent on its proper use, therefore:
Prior to working with the product, you should read all the instruction and keep it around.
For any damage caused by failure to comply with safety regulations and instructions of this manual, the supplier is not respon-
sible.
PRODUCT EQUIPMENT
The product is supplied in a complete state and requires no assembly. The product is supplied with screws, dowels, which allow
you for the set assembly.
TECHNICAL DATA
Parameter
Unit
Value
Catalogue No
YT-81860
Rated voltage
[V]
3.7 DC
Rated power
[W]
4
Electric insulation class
III
Degree of protection
IP44
Number of lighting LEDs
60
Life span of LEDs
[h]
20 000
The number of cycles on / o
ff
> 15 000
Color temperature of light
[K]
4,000
Luminous
fl
ux
[lm]
380
Luminous
fl
ux angle
[
O
]
120
Lighting time
[h]
3
Solar panel
- rated voltage
[V]
6 DC
- power
[W]
0.55
- e
ffi
ciency
[%]
17
Battery
Li-Ion
= rated voltage
[V]
3.7 DC
- capacity
[mAh]
2200
- e
ffi
ciency
[Wh]
8.14
- charging time
[h]
6
Sensivity of the twilight sensor
[lx]
<10
Delay time of the motion sensor
[s]
30
Detection angle of the motion sensor
[
O
]
120
Detection distance of the motion sensor
[m]
10
Weight
[kg]
0.14
PRODUCT INSTALLATION
It is required that the installation of lamp is carried out by a quali
fi
ed electrician .
spotlight and the solar panel should be mounted to the base using the mounting holes in their holders. Place for the solar panel
assembly should be chosen so that any obstacles can obscure a way of sunlight to the solar panel. The place for the product
installation should be selected so that it would remain within the connecting cable coming out of the solar panel, and, at the same
time the motion sensor should not be obscured at the distance of detection. For both the solar panel and the motion sensor, the
above-described obstacles should not also be transparent.
You should avoid locations exposed to a high temperature or
fl
ame. The lamp should not be exposed to vibration. The lamp shold
not be mounted under the water.
Because of the motion sensor operation there should be avoid any places where within the detection range will be located moving
objects, which may cause unintended turning on the lamp, eg. trees branches.
Recommendations for the assembly are illustrated on the
fi
gure (II).
