n
Set Ethernet parameters
The dialog field for pre-setting an Ethernet address is to be found
at
‘Start
è
Settings
è
Network and Dial-up Connections’
. The
default setting is address assignment via DHCP.
n
System properties (System)
Here you receive information about the version of the current Win-
dows
Ò
operating system, the memory load and sharing (altera-
tions here are not taken over into the registry) and about the copy-
right. The register Device Name allows you to change the
device
name
that is e.g. shown during Ethernet communication.
n
Set the back-lighting
Via
‘Start
è
Settings
è
Control Panel
è
Power Properties’
you
may set the break time and the dimming of the back-lighting. For
this choose AC Power at "Power Scheme" and then set the appro-
priate time.
A set suspend mode shuts down the Touch Panel com-
pletely. By switching the power supply off and on again
you can restart the Touch Panel.
To configure the optional MPI/DP interface on the Touch Panel start
via
‘Start
è
Settings
è
Control Panel’
or via "Settings" in the VIPA
Startup-Manager the tool "MPI/DP Slave Configuration".
Default: MPI - Address 1
The following settings are only required if not communicate via
Movicon.
Via mode the interface could be set up on "DP slave".
Configuration MPI/DP
slave
VIPA HMI
Deployment under Windows CE 6.0 Core
Operating system Windows
Ò
Embedded CE 6.0 Core> Structure
HB160 | TP-ECO | 62E-MGC0 | GB | 16-02
39
