As internal permanent storage medium every Touch Panel has a flash disc with a size of
512Mbyte (about 380Mbyte user data). After the start of Windows
Ò
CE this memory is
listed as
Flashdisk
under
My Device
.
The connection of USB sticks and USB drives by use of the "Host"-USB-A interface is
supported by the Touch Panel. After connection the storage media is listed as
Hard Disk
under
My Device.
Here you can plug a CompactFlash
Ò
type II. The card may be plugged and removed
during runtime and is immediately listed as
Storage Card
at
My Device
.
Every CompactFlash
Ò
storage module has a pulling edge. Hold the CompactFlash in the
way that the pulling edge points to the left side. Push the storage module without much
power into the slot until the impact. To remove the card touch it at the pulling edge and
pull.
On this slot you can plug storage modules of the type SD or MMC. The card may be
plugged and removed during runtime and is immediately listed as
SDMMC Card
at
My
Device
.
Please take care to plug the according card as shown on the back of the Touch Panel.
On the left side of the Touch Panel are the card slots for memory cards. The cards are
visibly covered by a security flap and are thus secured from slipping out.
Please take care to pull the security flap back before plugging or pulling a memory card
like shown in the illustration and put it back again afterwards. When plugging, the security
flap additionally snaps into position above the plugged memory card.
User memory
USB storage media
Slot for CF
Slot for SD/MMC
Security flap for memory
cards
VIPA HMI
Hardware description
Structure > Memory management
HB160 | TP | 62I-JID0 | en | 17-25
13
