9 Web Interface
YASKAWA
SIEP YEACOM 07A 1000-Series Option PROFINET SI-EP3 Technical Manual
45
Email Alerts Tab
The Email Alerts tab allows the user to configure four Email Fault/Alarm conditions. When the condition is true, one
email will be sent to the provided email address. Another email will not be sent until the condition becomes false and then
true again. A 30-second timer prevents emails from being sent when conditions reoccur immediately after being removed.
The timer helps limit the amount of emails sent regarding the same intermittent condition and helps to reduce network
traffic by reducing emails about reoccurring errors.
Figure 17
Figure 18 Email Alerts Tab View
Procedure: Conditional Email Set-up
1.
Define the condition that will trigger the email by selecting a monitor parameter, a comparator, and a value. Set
up comparator values for the range of values to check in the chosen condition. If choosing only one condition and
no OR or AND are needed, set the “OR/AND” drop-down selection to “NotUsed”.
2.
Enter the email address where the alert will be sent.
3.
Enter the message that will appear in the email contents.
4.
Enter the email subject.
5.
Click the “Email Active” check box to enable the alert.
Clicking “Save to device” will save the entered information into the option memory.
Clicking “Cancel and reload” will cancel any pending edits and display the most recently saved settings from the option
board.
