3-12
165559-1CD
HW1481993
DX200 Standard Setup
3 Programming Pendant Setup
3.2 Setting Up the Programming Pendant
7. When touch calibration is successfully done, the following window
appears.
8. Pressing [ENTER] key calls up the following window. Touch OK button
at the right top of the dialog box to close the box.
The following describes the procedure for installing application software
for the programming pendant.
In case that the operating-system software: NK.BIN has been already
installed, hold down [INTERLOCK], [9], and [SELECT] keys
simultaneously, and turn ON the DX200 main power supply to start up the
system with the display window as shown in procedure 8.
Then, touch “OK” button on the window and perform the installation of
application software following the procedures from 9.
9. Use the pen to touch the left bottom, and the task bar appears. Then
touch “START” in the task bar.
OK button
Touch here to display
“START” indication.
21/44
