YASKAWA Lift Inverter L1000V, Техническое руководство, Страница: 76 / 282

76 YASKAWA EUROPE SIEP YASKAWA AC Drive L1000V Technical Manual
4.4 Start-Up Flowcharts
4.4 Start-Up Flowcharts
This section covers basic setup for the drive, including Auto-Tuning procedures and corresponding flowcharts. Refer to
Types of Auto-Tuning on page 80 for details on the types of Auto-Tuning.
u
Flowchart A: Installation, Wiring, Basic Setup for Motor and Elevator
The flowchart below covers the basic procedure required to install the drive, motor, and elevator.
Figure 4.7
Figure 4.7 Installation, Wiring, Basic Setup for Motor and Elevator
Flowchart Purpose Page
A Installation, wiring, and basic steps required to setup the motor and elevator for operation. 76
B Auto-Tuning for induction motors. 79
Remember that the motor contactor(s) must be closed to perform
this procedure. Perform Rotational Auto-Tuning only if the ropes
are removed.
START
Install the drive as explained in
Wire the drive as explained in
Apply main power to the drive.
Adhere to safety messages concerning application of power.
Perform Auto-Tuning for motor parameters.
Perform a test run.
Fine-tuning
• Adjust settings for the brake sequence (S1- ) .
• Adjust speed control loop (C5- ) etc.
FINISH
Set up:
• Preset speed references (d1- )
• Acceleration/deceleration ramp (C1- )
• Jerk settings (C2- )
Assign functions to the digital I/O terminals using
parameters H1- and H2-
Set the Speed Reference Selection mode
parameter d1-18
Set the Unit Length in parameter o1-12.
Set up o1-20 to o1-22 and then select the display units for speed,
acceleration and deceleration ramp and jerk settings in o1-03.
Set up the Inspection Operation sequence.
Set up the PG encoder in F1- parameters when using single-track
feedback to the pulse train input RP. Set H6-01 to 3.
Select the control mode in parameter A1-02.
Check the motor rotation direction.
Mechanical Installation on page 31
.
Main Circuit Wiring on page 50
.