YASKAWA GA800 Series, Техническое обслуживание и устранение неисправностей

Страница: 318 / 566

4.7 Install the Keypad in a Control Panel or Another Device
318 YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting
4.7 Install the Keypad in a Control Panel or Another Device
◆
Operate the Keypad from a Remote Location
You can remove the keypad from the drive and connect it to a remote control extension cable 3 m (9.8 ft) long to
make operation easier when you cannot access the drive. It is not necessary to open or close the panel door to operate
a drive that is in a control panel. To order optional accessories, contact Yaskawa or your nearest sales representative.
Name Option Model Intended Use
Keypad Remote Cable
UWR0051: 1 m (3.3 ft)
UWR0052: 3 m (9.8 ft)
To connect the keypad and drive.
This option is an RJ-45, 8-pin straight-through UTP CAT5e cable.
Installation Support Set A 900-192-933-001
To attach the keypad to the control panel. This option uses screws.
Installation Support Set B 900-192-933-002
To attach the keypad to the control panel. This option uses nut clamps.
Use this option when weld studs are located in the control panel.
◆
Connect the Keypad from a Remote Location
Use the information in Table 4.7 to install the keypad in the best location for your application.
Table 4.7 Keypad Installation Method
Installation Method Features Necessary Tools and Installation Support Sets
Outside of the control panel
Simplified installation is possible. Separate installation
support sets are not necessary.
Phillips screwdriver #2 (M3)
Inside of the control panel
Keypad does not extend farther than the front of the control
panel.
• Phillips screwdriver #2 (M3, M4)
• Installation support set A (for mounting with screws,
model: 900-192-933-001)
•
Phillips screwdriver #2 (M3)
•
Wrench (M4)
•
Installation support set B (for mounting with nut clamp,
model: 900-192-933-002)
Note:
Installation support sets are sold separately. If there are weld studs inside the control panel, use installation support set B. Contact Yaskawa
or your nearest sales representative to make an order.
NOTICE: Do not let unwanted objects, for example metal shavings or wire clippings, fall into the drive during drive installation. Put a
temporary cover over the drive during installation. Remove the temporary cover before start-up. Unwanted objects inside of the
drive can cause damage to the drive.
■
External Dimensions of Keypad
Figure 4.10 Exterior and Mounting Dimensions