DWG. NO. 02Y00025-0385
SHEET NO. 1 OF 4
R E L . 7 / 1 5 / 9 6
( m - df )
For GPD 333
Adjustable Frequency Drives
CHANGE RECORD
NCL SATELLITE
MODEL CM006
NOTE
This option may have been installed by the factory. However, certain steps can
only be completed at the installation site. Therefore, review and then perform
those steps which will complete the installation process.
CAUTION
Before installing this option, a TECHNICALLY QUALIFIED INDIVIDUAL who is
familiar with this type of equipment and the hazards involved, should READ THIS
ENTIRE INSTRUCTION SHEET.
CAUTION
The NCL Satellite board is an electrostatic sensitive device. Personnel must use
approved methods for handling this type of equipment.
WARNING
HAZARDOUS VOLTAGE CAN CAUSE SEVERE INJURY OR
DEATH. ENSURE ALL POWER SOURCES FEEDING DRIVE
ARE LOCKED IN THE "OFF" POSITION BEFORE INSTALLING
THIS OPTION.
INTRODUCTION
NCL is a communications network developed by MagneTek to accommodate multiple satellite devices (drives)
from a single PLC network node which serves as a gateway to other networks. NCL protocol is based on CAN
technology, featuring efficient real-time control via master/slave communication capability. NCL supports up to 30
satellite subnodes per gateway. The NCL satellite board will enable the drive to accept serial communication,
allowing the network to perform all functions available via the keypad or external I/O, and to access all drive data.
