YASKAWA CIPR-GA50C series, Техническое руководство

Страница: 476 / 766

12.3 b: Application
476 YASKAWA SIEPC71061753A GA500 Technical Manual
12.3 b: Application
b parameters set these functions:
•
Frequency reference source/Run command source
•
Stopping method settings
•
DC Injection Braking
•
Speed Search
•
Timer Function
•
PID control
•
Dwell function
•
Energy-Saving Control
◆
b1: Operation Mode Selection
b1 parameters set the operation mode for the drive.
■
b1-01: Frequency Reference Selection 1
No.
(Hex.)
Name Description
Default
(Setting Range)
b1-01
(0180)
Frequency Reference
Selection 1
Sets the input method for the frequency reference.
1
(0 - 4)
Note:
•
Push on the keypad to set the input mode to LOCAL and use the keypad to enter the frequency reference.
• If the frequency reference is 0 Hz or less than the value set in E1-09 [Minimum Output Frequency] and the drive receives the Run
command, the RUN LED on the keypad will flash. Examine the setting for the frequency reference input and enter a value ≥ E1-09.
0 : Keypad
Use the keypad to enter the frequency reference.
Use and on the keypad to change the frequency reference.
1 : Analog Input
Use MFAI terminals A1 and A2 to input an analog frequency reference with a voltage or current input signal.
•
Voltage Input
Refer to
Table 12.23 to use a voltage signal input to one of the MFAI terminals.
Table 12.23 Frequency Reference Voltage Input
Terminal
Terminal Signal
Level
Parameter Settings
Note
Signal Level
Selection
Function Selection Gain Bias
A1 0 - 10 V (Lower Limit
at 0)
H3-01 = 0 H3-02 = 0
[Frequency Reference]
H3-03 H3-04
-
0 - 10 V (Bipolar
Reference)
H3-01 = 1
A2 0 - 10 V (Lower Limit
at 0)
H3-01 = 0 H3-10 = 0
[Frequency Reference]
H3-11 H3-12 Set DIP switch S1 to “ V ” for
voltage input.
0 - 10 V (Bipolar
Reference)
H3-01 = 1
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV