YASKAWA CC-Link SI-C3, Руководство по установке

Страница: 51 / 139

8 CC-Link Data List
YASKAWA TOEP C730600 83A CC-Link Installation Manual 51
Remote
Regis
ter
Name Description Check Flag
• When RYB is enabled, the motor revolutions are
stored as min
-1 . Here, RXB (actual motor rotations)
is enabled.
•
The output frequency are stored in V/f Control or
PM Open Loop Vector mode.
RYB setting is disabled.
RW
R2
Response
Code:
• Sets 00 (Hex.) when there are no problems with
RW
W2
(Command Code) and RW
W3
(Write Data).
•
Sets 01 (Hex.) through 03 (Hex.) if an error occurs.
•
Response Code:
00 (Hex.): Normal
01 (Hex.): Write-mode error (attempted to write
during run, etc.)
02 (Hex.): Command code error
03 (Hex.): Data setting range error
RXF (Command Code Execute
Complete)
RW
R3
Read
Data
Data is set according to the command code.
Data in RW
R1
(Output Frequency) and Units
Table 8.7 Drive RW
R1
(Output Frequency) Data List
Conditions Drive → PLC
A1-02
[Control Method
Selection]
RYB
(Motor
Revolutions/
Output Frequency
Switch)
RXB
(Actual Motor
Rotations)
RW
R1
Data RW
R1
Units
0, 5
*1
-
OFF (output
frequency)
Output Frequency
Set in the drives
specified by
o1-03
[Frequency Display
Unit Selection]
in
output frequency.
1, 2, 3, 4, 6, 7, 8
OFF (motor
revolutions) ON (motor
revolutions)
Motor revolutions min -1
ON (output
frequency)
OFF (output
frequency)
Output Frequency
Set in the drives
specified by
o1-03
[Frequency Display
Unit Selection]
in
output frequency.
*1 Controls in the same way as A1-02 = 1 [Control Method Selection = V/f Control with Encoder] in A1-02 =
0 [V/f Control] and H6-01 = 3 [Terminal RP Pulse Train Function = Speed Feedback (V/F Control)] .