ASSEMBLY
UNPACKING
This product requires no assembly.
Carefully remove the product and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
WARNING:
If any parts are damaged or missing, do not
operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury.
If any parts are damaged or missing, please call
1
-
800
-
633
-
1501 for assistance.
PACKING LIST
−
Pruning Saw with Blade Cover
−
Charger and Battery Pack
−
Owner
’
s Manual
−
Hex Wrench
−
Oil Bottle
INSTALLING/REPLACING THE GUIDE BAR AND CHAIN
DANGER:
Never start the motor before installing the guide
bar, chain, chain cover and chain cover lock knob. Without
all these parts in place, the clutch can fly off or explode,
exposing the user to possible serious injury.
WARNING:
To avoid serious personal injury, read and
understand all the safety instructions provided.
WARNING:
Before performing any maintenance, remove
the battery pack from the saw. Failure to heed this warning
could result in serious personal injury.
CAUTION:
Always wear gloves when handling the bar and
chain; these components are sharp and may contain burrs.
WARNING:
Never touch or adjust the chain while the
motor is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the
chain to avoid possible serious lacerations.
NOTE:
When replacing the guide bar and chain, use only
identical replacement parts.
•
Remove the battery from saw.
•
Flip up the ring on the knob and loosen the pruning saw
lock knob counterclockwise.
•
Remove the chain cover.
•
Remove the bar and chain from the mounting surface.
•
Remove the old chain from the bar.
•
Lay out the new saw chain in a loop and straighten any links.
The cutters should face in the direction of the chain rotation.
If they face backwards, turn the loop over.
•
Place the chain drive links into the bar groove.
NOTE:
Make certain of the direction of the chain.
•
Position the chain so there is a loop at the back of the bar.
•
Hold the chain in position on the bar and place the loop
around the sprocket.
•
Fit the bar flush against the mounting surface so that the bar
studs are in the long slot of the bar.
NOTE:
When placing the bar on the bar studs, ensure that
the adjusting pin is in the chain tension pin hole.
5
LCS0620
-
1
