model no. 060-3999-2 | contact us: 1-866-523-5218
27
PROBLEM
POSSIBLE CAUSE
SOLUTION
Then handle is not
in position.
The snow thrower
does not start.
The motor is on,
but the impeller
does not turn.
The snow thrower
leaves a thin layer
of snow behind.
The bolts are not properly seated.
The switch is defective.
The extension cord is not connected to
the plug.
The extension cord is not connected to
the power source.
The belt is damaged.
The scraper is worn.
Make sure the bolts are correctly installed through the
handle bars. Check to see if the hand knobs are tight.
Refer to Assembling the Handle section in this manual.
Have the switch replaced by an authorized service
center.
Connect the plug on the snow thrower to the
extension cord.
Plug the extension cord into a live 120 V AC, 60 Hz
outlet.
Replace the belt (see the section entitled Inspecting/
Replacing the Drive Belt).
Inspect the scraper for wear or damage.
Replace the scraper (see the section Replacing the
Scraper).
Tr
oubleshooting
