Yardworks 060-2341-2, Инструкция по эксплуатации

Страница: 14 / 24

model no. 060-2341-2 | contact us: 1.866.523.5218
14
1. TRIMMING
- Do not cut wet grass because it tends to stick to the trimmer head and guard, prevents
proper discharge of grass clippings, and could cause you to slip and fall.
- Regularly remove clippings and dirt around the trimmer head with a switched off
trimmer.
- Work rhythmically, stand firmly with your feet apart. Cut from right to left so the
trimmings will be thrown away from the work area.
- Do not move the trimmer too fast as this will result in ineffective cutting and possible
damage.
- Cut repeatedly from up and down in layers when the grass is very high. Keep the
trimmer head at an angle of about 30° to the ground when trimming. Avoid pressing it
against the ground as this can ruin the lawn and damage the trimmer head.
- If you find that the nylon line is too short follow the instructions in the “Automatic line
feed system” or “To manually feed the line” section.
NOTE: Let the cutting device do the work. Let it work at its own pace, never press it into the
area to be cut.
Operation
!
WARNING: Use only 0.065” (1.65 mm) diameter cutting line.
Other sizes of line will not feed properly and will result in
improper cutting head function or can cause serious injury. Do
not use other material such as wire, string, rope, etc. Wire can
break off during cutting and become a dangerous projectile
that can cause serious injury.
!
WARNING: Make sure that the line is fed out before operation.
Make sure the motor is up to full speed before trimming.
!
WARNING: Always wear eye protection. Never lean over the trimmer
head. Rocks or debris can ricochet or be thrown into your eyes and
face, causing blindness or other serious injury.
Wear eye protection and heavy clothing. Hold front handle with one hand
and auxiliary handle with the other hand. Keep unit below waist level.
Work only from your right to left to ensure debris is thrown away from
you. Without bending over, keep line near and parallel to the ground
(perpendicular when edging) and not crowded into the material being cut.