model no. 060-2273-4 | contact us: 1 866 523 5218
model no. 060-2273-4 | contact us: 1 866 523 5218
!
electrocution:
Maintenance
Battery Pack
• Store the battery pack fully charged.
• Recharge the battery pack anytime you notice there is less power. Never let the battery
pack become completely discharged.
• Never recharge a battery pack that is already fully charged. Overcharging shortens the
battery life.
• Always recharge at a temperature of 14 to 113˚F (-10 to 45˚C). If the battery pack is hot,
let it cool down before recharging.
• After charging, the battery pack may be stored in the charger as long as the charger is not
plugged in.
Cutting Line
wound replacement spools.
• Always wind the line in the same direction as the arrow on the spool.
Cleaning
1. Wipe the outside of the grass trimmer with a dry, soft cloth. Do not hose down or wash
with water.
2. Scrape the guard and spool area to remove dried clippings and mud.
3. Brush or blow dust, debris, and grass clippings out of the air vents. Keep them free of
obstruction.
CAUTION:
Do not use strong solvents or detergents on the plastic housing or plastic
components.
Certain household cleaners may cause damage and may also cause a
shock hazard.
•
•
Do not use a damp cloth or detergent on the battery
or battery charger.
•
Always remove the battery pack before cleaning,
inspecting, or performing any maintenance on the
grass trimmer.
14
15
Charger Maintenance
• Keep the charger clean and clear of debris. Do not allow foreign material into the recessed
cavity or on the contacts. Wipe with a dry cloth. Do not use solvents, water, or place in wet
conditions.
• Always unplug the charger when there is no battery pack in it.
• Give the batteries a full charge before placing in storage. Do not recharge a fully charged
battery pack. Overcharging shortens the battery life.
• Check that the charger contacts have not been shorted by debris or foreign material.
• If the surrounding air temperature is not normal room temperature, move the charger
and battery pack to a location where the temperature is between 14 and 113˚ F (-10
and 45˚ C).
If your device is not operating properly, follow the instructions below. If this does not
solve the problem, please contact your local repair agent.
Tool runs slowly
•
Check that the spool housing can rotate freely. Carefully clean it if necessary.
•
Check that the cutting line does not protrude more than 11cm from the spool housing. If
it does, cut it off so that it just reaches the line trimming blade.
Automatic line feed does not work.
•
Press the tabs and remove the spool cover from the housing.
•
is left on the spool, install a new spool of cutting line as instructed in the Maintenance
section of this Manual.
•
Align the tabs on the spool cover with the cut outs in the housing.
•
Push the cover onto the housing until it snaps securely into place.
•
If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches
the blade.
•
If the automatic line feed still does not work or the spool is jammed, try the following
suggestion:
•
Carefully clean the spool cover and housing.
•
Remove the spool and check if the lever can move freely.
•
Remove the spool and unwind the cutting line, then wind it on neatly again as
describe above. Replace the spool as instructed.
Lubrication
No lubrication is needed.
!
WARNING! Before proceeding, switch off
and unplug.
Troubleshooting
