model number 060-1500-0 | contact us: 1 866 523-5218
model number 060-1500-0 | contact us: 1 866 523-5218
10
11
WARNING
:
Clean any grinding compound or debris from
cutter bar blade, reel blade, pinions and pawls.
NOTE:Use industrial or value tapping compound between 100
wheel bearing grease.
such as dandelions and may bend the weeds instead of cutting
them.
Cut often to prevent long weeds from growing. When
lengths are long weeds and tall grass will fold before contacting
the cutting bar.
Operation
Safety and Maintenance
!
!
CHECKING THE ADJUSTMENT
The cutting mechanism is preset. After a long period of use it may need to be
readjusted. Check cutting performance and adjust if necessary.
1. Adjust the space between reel blades and cutter bar.
2. Turn the screw clockwise to move the lower blade towards the spindle blade.
Turn the screw counter-clockwise to move the lower blade away from the spindle
blade.
3. When the space equals the thickness of paper (0.12 mm), insert a piece of
paper between the blades and the cutter bar, and quickly turn the wheel by hand.
4. All blades should slice the paper evenly.
IMPORTANT SAFETY INFORMATION
• Never place hands, fingers, or feet inside the
reel. Although a motor does not power this
mower, when the wheels turn the reel spins
and poses a cutting risk.
• Never mow when grass is wet as it can be
slippery.
• Do not use the reel mower while barefoot or
while wearing sandals.
• Walk behind and never run while using reel
mower. Always make sure of your footing when
using this reel mower.
• Never intentionally strike or hit trees, fences,
etc. This can cause injuries or severely damage
the reel mower mechanisms.
• Make sure your reel mower is in a safe
operating condition. Do not attempt to operate
this reel mower if damaged.
• Contact customer service or have the reel
mower repaired by a qualified repair service
provider before using
.
CARE AND MAINTENANCE
1. Aminimum amount of care is required to
ensure smooth operation of your mower.
2. To avoid damage to mower or cutting blades,
keep area to be mowed free of debris.
3. For best results, regularly apply lubricant to
mower’s cutting surfaces, cutting reel axle shaft
and wheels.
SHARPENING THE CUTTING BLADES:
1. Spread a thin layer of lapping compound on
the front edge of the reel blades.
2. Adjust the cutter bar so that the blade has light
but firm contact across the full width of the cutter
bar.
Caution: Do not overtighten the adjusting screws,
as this could damage the cutter bar. Tighten both
screws during final adjustment.
3. Turn the reel blades until the front edge of the
cutter bar blade is polished.
CLEANING AND STORAGE
1.Clean the exterior of the machine thoroughly
using a soft brush and cloth before storing. Do not
use water, solvents or polishes.
2.Turn the mower on its side to clean the blade
area.
WARNING:
Do not place hands in the mower near
blades. If grass cuttings are compacted in the blade
area, remove using a wood or plastic cleaning tool
appropriate for the cleaning of the blades.
3. Store the mower in a dry place. Do not place other
objects on top of the mower during storage.
CARE AND MAINTENANCE
Maintenance tip:
Reel mowers are relatively low maintenance. For
consistent cutting follow these below instructions:
• Always keep the cutting bar properly adjusted.
Refer to the instruction manual for further
directions.
• Regularly clean and lube cutting edges with light
spray oil.
Made in China. Imported by YardWorks Canada Toronto,
Canada M4S 2B8
!
d
d
=
=
0.12mm
1
2
3
4
