7
■
■
■
■
■
FLOW ANGLE ADJUSTMENT CONTROL CABLE
Attach the Z type end of the cable into the lever as shown. (See
Figure
7,
illustration
1)
Secure the buckle on the cable onto the upper handle. (See
Figure
7,
illustration
2)
Secure the cable on the frame tube with cable clamp. (See
Figure
7,
illustration
3)
Figure 7
11
I
Assembly
■
■
■
■
■
FRONT DISCHARGE CHUTE
� NOTE
The front discharge chute is used to
redirect the air flow to the front of
the blower. Attach it when needed.
Loosen the knob located on top of the discharge chute.
Orient the attachment so the "THIS SIDE UP DURING USE" is up.
Slide the attachment over the discharge chute. The slot on the top
of the attachment will mate with the bolt of the attachment knob.
Hand-tighten the attachment knob to secure the attachment. (See
FigureB)
� NOTE
FigureB
When properly assembled, the
attachment knob will fit inside of
the round emboss
on
the top of the
attachment.
